BACK-UP LIGHT SWITCH INSPECTION

PROCEDURE


  1. INSPECT BACK-UP LIGHT SWITCH ASSEMBLY


    1. A01VJM1E06
      Text in Illustration
      *a

      Component without harness connected

      (Back-up Light Switch Assembly)
      *b 1.1 mm (0.0433 in.)
      *c ON (Pushed in)
      *d OFF (Released)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 ON (Pushed in) Below 1 Ω
      1 - 2 OFF (Released) 10 kΩ or higher

      If the result is not as specified, replace the back-up light switch assembly.