TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER BRACKET

    Click here

  7. REMOVE BATTERY

    Click here

  8. REMOVE BATTERY TRAY

    Click here

  9. REMOVE BATTERY CARRIER (for LHD)

    Click here

  10. REMOVE BATTERY CARRIER (for RHD)

    Click here

  11. REMOVE NO. 1 AIR TUBE


    1. A01VHSD

      Disengage the wire harness clamp.

    2. Remove the bolt and separate the wire harness.

    3. Loosen the 2 hose clamps.

    4. Remove the 2 nuts and the No. 1 air tube.

  12. REMOVE EXHAUST PIPE

    Click here

  13. REMOVE REAR CONSOLE BOX

    Click here

  14. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  15. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A01VLYHE02

      Remove the 2 A clips and separate the 2 cables from the control cable bracket.

    2. Remove the 2 B clips and disconnect the 2 cables from the manual transaxle assembly.

    3. A01VI3P

      Remove the 4 nuts and the transmission control cable assembly.