TRANSMISSION CONTROL CABLE(for TMMF Made) ADJUSTMENT

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE BATTERY

    Click here

  4. REMOVE BATTERY TRAY

  5. REMOVE BATTERY CARRIER

    Click here

  6. REMOVE REAR CONSOLE BOX

    Click here

  7. ADJUST TRANSMISSION CONTROL SELECT CABLE


    1. A004BAM

      Remove the clip and disconnect the transmission control select cable from the shift lever.

    2. A0047ZZE02
      Text in Illustration
      *1 Case
      *2 Lock Piece
      *3 Slider
      *a Before lock release
      *b After lock release
      A0049LZ Slide
      A004864 Push out

      Release the lock of the cable length adjustment structure of the transmission control select cable.


      1. Slide the slider.

      2. Push the lock piece downward to release the lock.

    3. A004AMCE04
      Text in Illustration
      *1 Reverse Restrict Pin Assembly
      *2 Outer Select Lever

      Hook the outer select lever of the manual transaxle assembly to the reverse restrict pin assembly to secure it.

    4. A00480BE02
      Text in Illustration
      *1 Slider Shaft
      *2 Cam Wall
      *3 Lock Piece
      *4 Slider
      A0049LZ Push
      A004864 Push in

      Connect the transmission control select cable to the floor shift shift lever assembly with the clip.

      Note

      Make sure that the lock piece protrudes from the adjuster case.

    5. Push the slider shaft until it contacts the cam wall.

      Note


      • Do not pull up the slider shaft.

      • When adjusting the cable, make sure that the shift lever is in neutral between the 1st and 2nd gear positions.

    6. Lock the cable length adjustment structure of the transmission control select cable.

      Note


      • Push the lock piece as far as it will go.

      • Confirm whether the cable length adjustment structure is locked securely.

    7. A0047A9E02
      Text in Illustration
      *1 Reverse Restrict Pin Assembly
      *2 Outer Select Lever
      *a Release

      Move the shift lever to the reverse position, so that the outer select lever can be released.

  8. INSTALL REAR CONSOLE BOX

    Click here

  9. INSTALL BATTERY CARRIER

    Click here

  10. INSTALL BATTERY TRAY

  11. INSTALL BATTERY

    Click here

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }