MANUAL TRANSAXLE ASSEMBLY(When Using the Engine Support Bridge for 2ZR-FE) COMPONENTS
ILLUSTRATION
| *1 | ENGINE UNDER COVER RH | *2 | ENGINE UNDER COVER LH |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | MANUAL TRANSMISSION DRAIN PLUG | *2 | MANUAL TRANSMISSION FILLER PLUG |
| *3 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | INNER COWL TOP TO COWL BRACE | *2 | OUTER COWL TOP PANEL |
| *3 | FRONT NO. 1 VENTILATOR SEAL | *4 | FRONT AIR SHUTTER SEAL RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | INNER COWL TOP TO COWL BRACE | *2 | OUTER COWL TOP PANEL |
| *3 | FRONT NO. 1 VENTILATOR SEAL | *4 | FRONT AIR SHUTTER SEAL RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT SUSPENSION UPPER CENTER BRACE SUB-ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | AIR CLEANER CAP WITH AIR CLEANER HOSE | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | BATTERY |
| *5 | BATTERY CARRIER | *6 | BATTERY CLAMP SUB-ASSEMBLY |
| *7 | BATTERY CLAMP BOLT | *8 | BATTERY TRAY |
| *9 | NO. 2 VENTILATION HOSE | *10 | AIR CLEANER BRACKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | EXHAUST PIPE GASKET | *2 | FRONT EXHAUST PIPE ASSEMBLY |
| *3 | FRONT FLOOR CENTER BRACE | *4 | COMPRESSION SPRING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | CLUTCH HOSE | *2 | ENGINE MOUNTING INSULATOR LH |
| *3 | TRANSMISSION CONTROL CABLE ASSEMBLY | *4 | STARTER ASSEMBLY |
| *5 | ENGINE WIRE | *6 | NO. 3 ENGINE WIRE |
| *7 | FLYWHEEL HOUSING SIDE COVER | *8 | WIRE HARNESS CLAMP BRACKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | for Bolt with Washer | *B | for Flange Bolt |
| *1 | ENGINE MOUNTING BRACKET SUB-ASSEMBLY LH | *2 | ENGINE MOVING CONTROL ROD BRACKET |
| *3 | MANUAL TRANSAXLE ASSEMBLY | *4 | WIRE HARNESS CLAMP BRACKET |
| *5 | RADIATOR HOSE CLAMP BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ★ | Precoated part |
ILLUSTRATION
| *1 | CLUTCH FLEXIBLE HOSE BRACKET | *2 | CLUTCH RELEASE BLEEDER SUB-ASSEMBLY |
| *3 | CLUTCH RELEASE CYLINDER TO BLEEDER TUBE | *4 | CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE |
| *5 | CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY | *6 | CLUTCH TUBE BOOT |
| *7 | SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY | *8 | O-RING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with a union nut wrench |
| ● | Non-reusable part |  |
Clutch spline grease |
 |
Manual transaxle oil | - | - |