TRANSMISSION CONTROL CABLE(for TMMF Made) INSTALLATION

PROCEDURE

1. Click here

   INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

   
   

   1. Install the transmission control cable assembly with the 4 nuts.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

   2. Install the 2 cables to the control cable bracket with 2 new clips.

   3. Connect the 2 cables to the transaxle and install the 2 clips.

   4. 

      Securely push the control cable into the grooved part of the shift lever with the protrusion of the control cable facing upward.

      Table 1. Text in Illustration

      Push

   5. Connect the control select cable to the shift lever with the clip.

      Note:
      

      • Connect the control select cable so that the adjusting mechanism lock of the control select cable is installed on the left side of the vehicle.

      • Do not apply excessive load to the shift lever.

   6. Connect the control shift cable to the shift lever.

2. Click here

   INSTALL FLOOR SHIFT LEVER ASSEMBLY

   Click here

3. Click here

   INSTALL REAR CONSOLE BOX ASSEMBLY

   (Click here)

4. Click here

   INSTALL FRONT NO. 2 FLOOR HEAT INSULATOR

   Click here

5. Click here

   INSTALL FRONT EXHAUST PIPE ASSEMBLY

   Click here

6. Click here

   CONNECT NO. 2 HEATED OXYGEN SENSOR CONNECTOR

   Click here

7. Click here

   INSTALL BATTERY CARRIER (for LHD)

   Click here

8. Click here

   INSTALL BATTERY CARRIER (for RHD)

   Click here

9. Click here

   INSTALL BATTERY TRAY

10. Click here

    INSTALL BATTERY

    Click here

11. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    5.4 N*m

    55 kgf*cm

    48 in.*lbf

12. Click here

    INSPECT FOR EXHAUST GAS LEAK