CLUTCH UNIT(for EC62) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    When the transaxle is removed, be sure to use a new clutch release cylinder with bearing assembly and new installation bolts. Removal of the transaxle allows the compressed clutch release cylinder with bearing assembly to return to its original position, and dust from the moving section could damage the seal of the clutch release cylinder with bearing assembly, possibly causing clutch fluid leaks.

  2. REMOVE MANUAL TRANSAXLE ASSEMBLY


    • When Using the Engine Support Bridge:

      Click here

    • When Not Using the Engine Support Bridge:

      Click here

  3. REMOVE NO. 1 CLUTCH HOUSING COVER


    1. B0046JX

      Remove the No. 1 clutch housing cover from the manual transaxle assembly.

  4. REMOVE CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE (for 2NR-FKE)


    1. B00482B

      Remove the 2 bolts and separate the 2 tube clamps from the manual transaxle assembly.

    2. Using a 10 mm union nut wrench, remove the clutch release cylinder to flexible hose tube from the clutch release bleeder sub-assembly.

  5. REMOVE CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE (for 2ZR-FE)


    1. B00456Z

      Remove the bolt and separate the clutch release cylinder to flexible hose tube from the manual transaxle assembly.

    2. Using a 10 mm union nut wrench, remove the clutch release cylinder to flexible hose tube from the clutch release bleeder sub-assembly.

    3. Remove the clamp from the clutch release cylinder to flexible hose tube.

  6. REMOVE CLUTCH FLEXIBLE HOSE BRACKET


    1. B00482T

      Remove the bolt and the clutch flexible hose bracket from the manual transaxle assembly.

  7. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY


    1. B00487R

      Using a 10 mm union nut wrench, disconnect the clutch release cylinder to bleeder tube from the clutch release bleeder sub-assembly.

    2. Remove the 2 bolts and the clutch release bleeder sub-assembly from the manual transaxle assembly.

  8. REMOVE RELEASE CYLINDER BLEEDER PLUG CAP


    1. Remove the release cylinder bleeder plug cap from the release cylinder bleeder plug.

  9. REMOVE CLUTCH TUBE BOOT


    1. B00489H

      Remove the clutch tube boot from the manual transaxle assembly.

  10. REMOVE CLUTCH RELEASE CYLINDER WITH BEARING ASSEMBLY


    1. B0046F8

      Remove the 3 bolts and the clutch release cylinder with bearing assembly and the clutch release cylinder to bleeder tube from the manual transaxle assembly.

  11. REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE


    1. B0047W1

      Using a 10 mm union nut wrench, remove the clutch release cylinder to bleeder tube from the clutch release cylinder with bearing assembly.

  12. REMOVE CLUTCH COVER ASSEMBLY


    1. B0045I5E02
      Text in Illustration
      *a Matchmark

      Put the matchmarks on the clutch cover assembly and the flywheel sub-assembly.

    2. Loosen each set bolt one turn at a time in the order shown in the illustration until the spring tension is released.

    3. Remove the set bolts and pull off the clutch cover assembly.

      Note

      Do not drop the clutch disc assembly.

  13. REMOVE CLUTCH DISC ASSEMBLY


    1. Remove the clutch disc assembly.

      Note

      Keep the lining part of the clutch disc and the surfaces of the pressure plate and flywheel free of oil and foreign matter.