CLUTCH UNIT(for C551) INSPECTION

PROCEDURE

1. INSPECT CLUTCH DISC ASSEMBLY

   
   

   1. 

      Using a vernier caliper, measure the rivet head depth.

      Minimum rivet depth
      0.3 mm (0.0118 in.)

      If necessary, replace the clutch disc assembly.

   2. 

      Text in Illustration

      *1	Clutch Disc Assembly
      *a	Transaxle side

      Install the clutch disc assembly to the manual transaxle assembly.

      Note

      Insert the clutch disc assembly in the correct direction.

   3. Using a dial indicator with a roller instrument, measure the clutch disc assembly runout.

      Maximum runout
      0.8 mm (0.0315 in.)

      If necessary, replace the clutch disc assembly.

2. INSPECT CLUTCH COVER ASSEMBLY

   
   

   1. 

      Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

      Maximum
      A (Depth)
      0.5 mm (0.0197 in.)
      B (Width)
      6.0 mm (0.236 in.)

      If necessary, replace the clutch cover assembly.

3. INSPECT FLYWHEEL SUB-ASSEMBLY

   
   

   1. 

      Using a dial indicator, measure the flywheel sub-assembly runout.

      Maximum runout
      0.1 mm (0.00394 in.)

      If necessary, replace the flywheel sub-assembly.

4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY

   
   

   1. 

      Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.

   2. Inspect the clutch release bearing assembly for damage and wear.

      If necessary, replace the clutch release bearing assembly.