CLUTCH SWITCH(for RHD) INSPECTION

PROCEDURE


  1. INSPECT CLUTCH SWITCH ASSEMBLY

    A01VHQDE36
    Text in Illustration
    *a

    Component without harness connected

    (No. 2 clutch start switch assembly)
    *b 7.65 to 8.35 mm (0.301 to 0.329 in.)

    1. Check the resistance between the terminals when the switch is ON and OFF.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      1 - 2 OFF (released) 10 kΩ or higher
      ON (pushed in) Below 1 Ω

      If the result is not as specified, replace the No. 2 clutch start switch assembly.