DATA LIST
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| CCS Vehicle Spd | Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Actual vehicle speed displayed | - |
| CCS Mem Vehicle Spd | Vehicle speed / Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph) | Vehicle speed stored in memory | - |
| Cruise Request Torque | Request torque / Min.: -32768 N, Max.: 32767 N | Actual vehicle torque | - |
| Cruise Control | Cruise control system active condition / ON or OFF | ON: Cruise control activated OFF: Cruise control deactivated |
- |
| Main SW M-CPU | Cruise control system standby condition (Main CPU) / OFF or ON | OFF: Cruise control main switch off ON: Cruise control main switch on |
- |
| CCS Indicator M-CPU | Cruise control indicator signal (Main-CPU) / ON or OFF | ON: Cruise control indicator illuminated OFF: Cruise control indicator not illuminated |
- |
| Cancel Switch | CANCEL switch signal / ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off |
- |
| SET/COAST Switch | -SET switch signal / OFF or ON | OFF: -SET switch off ON: -SET switch on |
- |
| RES/ACC Switch | +RES switch signal / OFF or ON | OFF: +RES switch off ON: +RES switch on |
- |
| Stop Light Switch 1 | Stop light switch signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Stop Light Switch 2 | Stop light switch signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
| Cruise Operation Status | Cruise control status / ON or OFF | ON: Cruise control operating OFF: Cruise control not operating |
- |
| Brake Cancel Switch | Brake cancel signal / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released |
- |
ACTIVE TEST
Tech Tips
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the GTS, perform the Active Test.
for TFT Display Type:
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF or All | - |
for Segment Display Type:
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. Lamp Cruise | Cruise control indicator light | OFF/ON | - |
| Indicat. SET | Cruise control SET indicator light | OFF/ON | - |