CRUISE CONTROL SYSTEM(for Gasoline) TC and CG Terminal Circuit

WIRING DIAGRAM

A01VHEKE01

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)


    1. Disconnect the A58 ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F4-13 (TC) - A58-23 (TC) Always Below 1 Ω
      F4-4 (CG) - Body ground
      F4-13 (TC) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR