CRUISE CONTROL SYSTEM(for Gasoline) Cruise SET Indicator Light Circuit

DESCRIPTION

When the ECM detects a cruise control main switch "on" signal from the cruise control main switch, it sends it to the combination meter through CAN communication. Then the cruise control SET indicator light turns on.

CAUTION / NOTICE / HINT

Note

First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.

PROCEDURE


  1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE CONTROL SET INDICATOR LIGHT)


    1. Using the intelligent tester, perform the Active Test Click here.


      1. for TFT Display Type

        Combination Meter
        Tester Display Test Part Control Range Diagnostic Note
        Meter Display 1 Multi-information display OFF or All -
        OK
        The multi-information display turns on or off according to the operation of the Active Test.

      2. for Segment Display Type

        Combination Meter
        Tester Display Test Part Control Range Diagnostic Note
        Indicat. SET Cruise control SET indicator light OFF/ON -
        OK
        Indicator light turns on/off.

    NG

    GO TO METER / GAUGE SYSTEM Click here

    OK

  2. READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL MAIN SWITCH)


    1. Using the intelligent tester, read the Data List Click here.

      Cruise Control
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Cruise Control Cruise control / OFF or ON

      OFF: Cruise control not set

      ON: Cruise control set

      		 -
      OK
      The display is as specified in the normal condition column.

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPLACE ECM Click here