STARTER(for Cold Area Specification Vehicles) COMPONENTS
ILLUSTRATION
| *A | for CVT | - | - |
| *1 | AIR CLEANER CAP SUB-ASSEMBLY | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | BATTERY |
| *5 | BATTERY CARRIER | *6 | BATTERY TRAY |
| *7 | AIR CLEANER HOSE ASSEMBLY | *8 | BATTERY CLAMP SUB-ASSEMBLY |
| *9 | BATTERY CLAMP BOLT | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for CVT | - | - |
| *1 | TRANSMISSION CONTROL CABLE ASSEMBLY | *2 | NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
| *3 | HEATER WATER HOSE INLET A | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | STARTER ASSEMBLY | *2 | FLYWHEEL HOUSING SIDE COVER |
| *3 | WIRE HARNESS CLAMP BRACKET | *4 | TERMINAL CAP |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | MAGNET SWITCH | *2 | PLANETARY GEAR |
| *3 | STARTER ARMATURE ASSEMBLY | *4 | STARTER ARMATURE PLATE |
| *5 | STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY | *6 | STARTER COMMUTATOR END FRAME ASSEMBLY |
| *7 | STARTER YOKE ASSEMBLY | *8 | STARTER DRIVE HOUSING ASSEMBLY |
| *9 | STARTER DRIVE LEVER SET PIN | *10 | REPAIR SERVICE STARTER KIT |
| *11 | PLATE WASHER | *12 | SNAP RING |
| *13 | STARTER COMMUTATOR END FRAME COVER | *14 | PLUNGER |
| *15 | RETURN SPRING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
High-temperature grease | - | - |