Click here

STARTER(for Transaxle CVT with Stop and Start System) INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL STARTER ASSEMBLY


    1. Install the wire harness clamp bracket to the starter assembly with the bolt.

      8.4 N*m 85 kgf*cm 74 in.*lbf

    2. Install the starter assembly to the cylinder block sub-assembly and oil pan sub-assembly with the 2 bolts.

      37 N*m 377 kgf*cm 27 ft.*lbf

    3. Engage the 2 clamps to connect the wire harness to the 2 wire harness clamp brackets.

    4. Connect the wire harness to the terminal 30 with the nut.

      14 N*m 143 kgf*cm 10 ft.*lbf

    5. Connect the terminal 50 connector.

    6. Close the terminal cap.

  2. Click here

    INSTALL FLYWHEEL HOUSING SIDE COVER


    1. A01VLCW

      Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block sub-assembly and while pushing it along the cylinder block sub-assembly, fit the claw into the cylinder block sub-assembly.

      Note:

      • Make sure that the claw makes a click sound, indicating that it fits tightly.


      • Replace the claw with a new one if it does not fit tightly or is deformed.

  3. Click here

    INSTALL TRANSMISSION CONTROL CABLE BRACKET

  4. Click here

    INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

  5. Click here

    INSTALL REAR CONSOLE BOX ASSEMBLY

    (Click here)

  6. Click here

    INSTALL BATTERY CARRIER

    Click here

  7. Click here

    INSTALL BATTERY TRAY

    Click here

  8. Click here

    INSTALL BATTERY

    Click here

  9. Click here

    CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    5.4 N*m 55 kgf*cm 48 in.*lbf
    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  10. Click here

    CLEAR NUMBER OF STARTER OPERATIONS

    Click here