STARTER(except Cold Area Specification Vehicles) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the wire harness clamp bracket.

      Torque:

      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

   2. Install the starter assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   3. Connect the connector.

   4. Connect terminal 30 with the nut.

      Torque:

      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

   5. Close the terminal cap.

2. INSTALL FLYWHEEL HOUSING SIDE COVER

   
   

   1. Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

      Note

      
      

      • Make sure that the claw makes a click sound, indicating that it fits tightly.

      • Replace the flywheel housing side cover with a new one if it does not fit tightly or is deformed.

3. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET

4. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

5. INSTALL REAR CONSOLE BOX

   Click here

6. INSTALL BATTERY CARRIER

   Click here

7. INSTALL BATTERY TRAY

   Click here

8. INSTALL BATTERY

   Click here

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

10. INSTALL ENGINE UNDER COVER RH