STARTER(except Cold Area Specification Vehicles) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ENGINE UNDER COVER RH

  4. REMOVE BATTERY

    Click here

  5. REMOVE BATTERY TRAY

    Click here

  6. REMOVE BATTERY CARRIER

    Click here

  7. REMOVE REAR CONSOLE BOX

  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    Click here

  9. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

  10. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A01VIMH

      Disengage the claw by pulling it outward and remove the flywheel housing side cover.

  11. REMOVE STARTER ASSEMBLY


    1. A01VHA6

      Disengage the 2 clamp.

    2. A01VDS1

      Open the terminal cap.

    3. Remove the nut and disconnect the terminal 30.

    4. A01VJ5R

      Remove the 2 bolts and the starter assembly.

    5. Remove the bolt and wire harness clamp bracket.