STARTER(for Cold Area Specification Vehicles) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BATTERY

    Click here

  4. REMOVE BATTERY TRAY

    Click here

  5. REMOVE BATTERY CARRIER

    Click here

  6. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A01VG16

      Disengage the claw while pulling it upward and remove the flywheel housing side cover from the cylinder block sub-assembly.

  7. REMOVE BATTERY


    1. Open the terminal cap.

    2. A01VHU1

      Disconnect the terminal 50 connector.

    3. A01VFMA

      Remove the nut to disconnect the wire harness from the terminal 30.

    4. Disengage the 2 clamps to disconnect the wire harness from the 2 wire harness clamp brackets.

    5. A01VLHC

      Remove the 2 bolts and starter assembly from the cylinder block sub-assembly and oil pan sub-assembly.

    6. A01VENV

      Remove the bolt and wire harness clamp bracket from the starter assembly.