STARTER(w/o Stop And Start System) REMOVAL

Click here

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. Click here

   REMOVE ENGINE UNDER COVER RH

4. Click here

   REMOVE BATTERY

   Click here

5. Click here

   REMOVE BATTERY TRAY

   Click here

6. Click here

   REMOVE BATTERY CARRIER

   Click here

7. Click here

   REMOVE REAR CONSOLE BOX

8. Click here

   REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

   (Click here)

9. Click here

   REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

10. Click here

    REMOVE FLYWHEEL HOUSING SIDE COVER

    
    
    1. 

       Disengage the claw by pulling it outward and remove the flywheel housing side cover.

11. Click here

    REMOVE STARTER ASSEMBLY

    
    
    1. 

       Disengage the 2 clamp.

    2. 

       Open the terminal cap.

    3. Remove the nut and disconnect the terminal 30.

    4. 

       Remove the 2 bolts and the starter assembly.

    5. Remove the bolt and wire harness clamp bracket.