STARTER(w/ Stop And Start System) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. Install the wire harness clamp bracket.

      Torque:
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    2. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Connect the connector.

    4. Connect terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Close the terminal cap.

    6. Install the bracket with the bolt.

      Torque:
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    7. Engage the clamp.

  2. INSTALL FLYWHEEL HOUSING SIDE COVER


    1. Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

      Note


      • Make sure that the claw makes a click sound, indicating that it fits tightly.


      • Replace the claw with a new one if it does not fit tightly or is deformed.

  3. INSTALL REAR CONSOLE BOX

  4. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET

    Click here

  5. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

  6. INSTALL BATTERY CARRIER

    Click here

  7. INSTALL BATTERY TRAY

    Click here

  8. INSTALL BATTERY

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  10. INSTALL ENGINE UNDER COVER RH

  11. CLEAR NUMBER OF STARTER OPERATIONS

    Click here