STARTER(w/ Stop And Start System) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE ENGINE UNDER COVER RH

  4. REMOVE BATTERY

    Click here

  5. REMOVE BATTERY TRAY

    Click here

  6. REMOVE BATTERY CARRIER

    Click here

  7. REMOVE REAR CONSOLE BOX

    Click here

  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

  9. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

  10. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A01VIMH

      Disengage the claw by pulling it outward and remove the flywheel housing side cover.

  11. REMOVE STARTER ASSEMBLY


    1. A01VK9S

      Disengage the 2 clamp.

    2. A01VLDW

      Open the terminal cap.

    3. Remove the nut and disconnect the terminal 30.

    4. Disconnect the connector.

    5. A01VKNI

      Remove the 2 bolts and the starter assembly.

    6. A01VGPR

      Remove the bolt and wire harness clamp bracket.