STARTER(for Transaxle M/T with Stop and Start System) INSTALLATION

PROCEDURE

1. INSTALL FLYWHEEL HOUSING SIDE COVER

   Click here

2. INSTALL STARTER ASSEMBLY

   Tech Tips

   Perform "clear number of starter operations" after replacing a starter assembly.

   Click here

   
   

   1. Install the wire harness clamp bracket to the starter assembly with the bolt.

      Torque:

      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

   2. Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      After the starter assembly is replaced, be sure to clear the number of starter operations stored in the engine stop and start ECU.

   3. Engage the clamp to connect the wire harness to the wire harness clamp bracket.

   4. Connect the wire harness to the terminal 30 with the nut.

      Torque:

      13.5 N*m  { 138 kgf*cm, 10 ft.*lbf }

   5. Close the terminal cap.

   6. Connect the starter assembly connector.

3. INSTALL BATTERY CARRIER

   Click here

4. INSTALL BATTERY TRAY

   Click here

5. INSTALL BATTERY

   Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

7. PERFORM INITIALIZATION

   
   

   1. Perform "clear number of starter operations" after replacing a starter assembly.

      Click here