STARTER(for Transaxle M/T with Stop and Start System) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE BATTERY

    Click here

  4. REMOVE BATTERY TRAY

    Click here

  5. REMOVE BATTERY CARRIER

    Click here

  6. REMOVE STARTER ASSEMBLY

    Tech Tips

    When the starter assembly is replaced, starter relay assembly must be also replaced.


    1. B004599

      Disconnect the starter assembly connector.

    2. B00484N

      Open the terminal cap.

    3. Remove the nut to disconnect the wire harness from the terminal 30.

    4. Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.

    5. B0047LJ

      Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.

      Note

      After the starter assembly is replaced, be sure to clear the number of starter operations stored in the engine stop and start ECU.

      Click here

    6. B0046B5

      Remove the bolt and wire harness clamp bracket from the starter assembly.

  7. REMOVE FLYWHEEL HOUSING SIDE COVER

    Click here