STARTER(for Transaxle CVT with Stop and Start System) REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. Click here

   REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

4. Click here

   REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

   Click here

5. Click here

   REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click here

6. Click here

   REMOVE BATTERY

   Click here

7. Click here

   REMOVE BATTERY TRAY

   Click here

8. Click here

   REMOVE BATTERY CARRIER

   Click here

9. Click here

   DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

   Click here

10. Click here

    REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

    Click here

11. Click here

    DISCONNECT HEATER WATER HOSE INLET A

    
    
    1. 

       Disengage the clamp to disconnect the heater water hose inlet A from the heater bracket.

12. Click here

    REMOVE STARTER ASSEMBLY

    Tip:

    When the starter assembly is replaced, starter relay assembly must be also replaced.

    
    
    1. 

       Disconnect the starter assembly connector.

    2. 

       Open the terminal cap.

    3. Remove the nut to disconnect the wire harness from the terminal 30.

    4. Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.

    5. 

       Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.

       Note:

       After the starter assembly is replaced, be sure to clear the number of starter operations stored in the engine stop and start ECU.

       Click here

    6. 

       Remove the bolt and wire harness clamp bracket from the starter assembly.

13. Click here

    REMOVE FLYWHEEL HOUSING SIDE COVER

    Click here