STARTER(w/o Stop and Start System for Cold Area Specification Vehicles) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   2. Engage the clamp to connect the wire harness to the wire harness clamp bracket.

   3. Connect the terminal 50 connector.

   4. Connect the wire harness to the terminal 30 with the nut.

      Torque:

      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

   5. Close the terminal cap.

2. INSTALL NO. 2 AIR TUBE ASSEMBLY

   Click here

3. INSTALL CENTER ENGINE UNDER COVER

   Click here

4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

   Click here

5. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

   Click here

6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

   Click here

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.