STARTER(for Cold Area Specification Vehicles) DISASSEMBLY

PROCEDURE


  1. REMOVE STARTER TERMINAL


    1. A01VJZA

      Open the terminal cap.

    2. Remove the nut and starter terminal from the magnet starter switch assembly.

  2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    1. A01VFXU

      Remove the nut to disconnect the lead wire from the terminal C.

    2. A01VFUN

      Remove the 2 nuts.

    3. A01VHJGE08
      Text in Illustration
      *1 Starter Pinion Drive Lever
      *a Hook

      While lifting the rear of the magnet starter switch assembly, release the hook from the starter pinion drive lever, then remove the magnet starter switch assembly.

  3. REMOVE STARTER YOKE ASSEMBLY


    1. A01VGLW

      Using "TORX" socket wrench T25, remove the 2 through bolts.

    2. A01VJNI

      Pull out the starter yoke assembly together with the starter armature assembly to remove it from the starter drive housing.

  4. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


    1. A01VJUS

      Remove the 2 screws.

    2. A01VE9TE01
      Text in Illustration
      *1 Starter Yoke Assembly
      *2 Starter Commutator End Frame Assembly

      Remove the starter commutator end frame assembly from the starter yoke assembly.

      Note

      While holding down the lead wire, remove the starter commutator end frame assembly.

  5. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    1. A01VKYX

      Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

    2. Disconnect the 4 brushes, and remove the starter brush holder assembly.

  6. REMOVE STARTER ARMATURE ASSEMBLY


    1. A01VF1HE02
      Text in Illustration
      *1 Starter Yoke Assembly
      *2 Starter Armature Assembly

      Remove the starter armature assembly from the starter yoke assembly.

  7. REMOVE STARTER ARMATURE PLATE


    1. Remove the starter armature plate from the starter drive housing or starter yoke assembly.

      A01VDQME04
      Text in Illustration
      *1 Starter Drive Housing *2 Starter Yoke Assembly
      *3 Starter Armature Plate - -

  8. REMOVE PLANETARY GEAR


    1. A01VGB6

      Remove the 3 planetary gears from the starter center bearing clutch sub-assembly.

  9. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    1. A01VIZU

      Remove the rubber seal from the starter drive housing.

    2. A01VDJ7E03
      Text in Illustration
      *1 Starter Pinion Drive Lever
      *2 Starter Center Bearing Clutch Sub-assembly

      Remove the starter center bearing clutch sub-assembly with starter pinion drive lever from the starter drive housing.

    3. Remove the starter pinion drive lever from the starter center bearing clutch sub-assembly.

  10. REMOVE DUST STARTER PROTECTOR

    A01VJW3

    1. Remove the dust starter protector from the starter yoke assembly.