STARTER(for Cold Area Specification Vehicles) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. REMOVE CENTER ENGINE UNDER COVER

  7. REMOVE NO. 2 AIR TUBE ASSEMBLY

    Click here

  8. REMOVE STARTER ASSEMBLY

    A01VKZZ

    1. Open the terminal cap.

    2. Remove the nut to disconnect the wire harness from the terminal 30.

    3. Disconnect the terminal 50 connector.

    4. Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.

    5. A01VM2M

      Remove the 2 bolts and starter assembly from the cylinder block sub-assembly.