STARTER(w/ Stop And Start System) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY

    Tech Tips

    When replacing the starter assembly, it is necessary to replace the ST1 relay and ST2 relay.


    1. A01VM2M

      Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }
    2. A01VHQ3

      Connect the terminal 30 with the nut.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

    3. Connect the starter assembly connector.

    4. Close the terminal cap.

  2. INSTALL NO. 2 AIR TUBE ASSEMBLY

    Click here

  3. INSTALL CENTER ENGINE UNDER COVER

    Click here

  4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }