GLOW PLUG ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT GLOW PLUG ASSEMBLY


    1. Remove the glow plug connector Click here.

    2. A01VJZL

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Glow plug terminal - Ground 20°C (68°F) Approx. 1.0 Ω

      Note


      • Do not damage the glow plug pipes as this could cause an open circuit or shorten the life of the glow plugs.

      • Prevent oil and fuel from spraying onto the glow plugs when cleaning.

      • Wipe any oil off the terminal and the Bakelite washer with a dry cloth if they are stained with oil during the inspection.

      If the result is not as specified, replace the glow plug.

    3. Install the glow plug connector Click here.