IGNITION SWITCH INSPECTION

PROCEDURE


  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    1. A01VJEDE01
      Text Illustration
      *a

      Component without harness connected

      (Ignition Switch Assembly)
      *b LOCK
      *c ACC
      *d ON
      *e START

      Check the resistance.


      1. Using an ohmmeter, measure the resistance between the terminals.

        Standard resistance
        Tester Connection Switch Connection Specified Condition
        Between all terminals LOCK 10 kΩ or higher
        2(ACC) - 4(AM1) ACC Below 1 Ω
        1(IG1) - 2(ACC) - 4(AM1) ON Below 1 Ω
        5(AM2) - 6(IG2)
        1(IG1) - 4(AM1) START Below 1 Ω
        5(AM2) - 6(IG2) - 7(ST2)

        If the result is not as specified, replace the ignition switch assembly.