IGNITION SWITCH INSPECTION

PROCEDURE


  1. INSPECT IGNITION OR STARTER SWITCH ASSEMBLY


    1. Check the resistance.

      A01VGTBE01
      Text in Illustration
      *A for TMC Made
      *B for TMMF Made
      *a

      Component without harness connected

      (Ignition Switch Assembly)
      *b LOCK
      *c ACC
      *d ON
      *e START

      1. Measure the resistance according to the value(s) in the table below.

        Standard resistance
        Tester Connection Switch Connection Specified Condition
        Between all terminals LOCK 10 kΩ or higher
        2(ACC) - 4(AM1) ACC Below 1 Ω
        1(IG1) - 2(ACC) - 4(AM1) ON Below 1 Ω
        5(AM2) - 6(IG2)
        1(IG1) - 4(AM1) START Below 1 Ω
        5(AM2) - 6(IG2) - 7(ST2)

        If the result is not as specified, replace the ignition switch assembly.