STARTER(for TMC Made Cold Area Specification Vehicles) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the engine wire harness bracket with the bolt.

      Torque:

      8.4 N*m  { 85 kgf*cm, 73 in.*lbf }

   2. Install the starter assembly with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   3. Connect the connector

   4. Connect terminal 30 with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   5. Close the terminal cap.

   6. Install the harness clamp.

2. INSTALL FLYWHEEL HOUSING SIDE COVER

   
   

   1. Insert the protruding portion into the end of the cylinder block and while pushing it along the cylinder block, fit the claw into the cylinder block.

      Note

      
      

      • Make sure that the claw makes a click sound, indicating that fits tightly.

      • Replace the claw with a new one if it does not fit tightly or is deformed.

3. INSTALL BATTERY TRAY

   Click here

4. INSTALL BATTERY

   Click here

5. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

6. INSTALL ENGINE UNDER COVER RH

   Click here