STARTER(w/ Stop And Start System) INSTALLATION

PROCEDURE

1. Click here

   INSTALL STARTER ASSEMBLY

   
   

   1. Install the wire harness clamp bracket to the starter assembly with the bolt.

      8.0 N*m

      86 kgf*cm

      74 in.*lbf

   2. Install the starter assembly to the cylinder block sub-assembly and oil pan sub-assembly with the 2 bolts.

      37 N*m

      377 kgf*cm

      27 ft.*lbf

   3. Engage the clamp to connect the wire harness to the wire harness clamp bracket.

   4. Connect the terminal 50 connector.

   5. Connect terminal 30 to the starter assembly with the nut.

      14 N*m

      138 kgf*cm

      10 ft.*lbf

   6. Close the terminal cap.

2. Click here

   INSTALL FLYWHEEL HOUSING SIDE COVER

   
   
   1. 

      Insert the protruding portion of the flywheel housing side cover into the end of the cylinder block sub-assembly, fit the claw into the cylinder block sub-assembly.

      Note:
      

      • Make sure that the claw makes a click sound, indicating that it fits tightly.

      • Replace the claw with a new one if it does not fit tightly or is deformed.

3. Click here

   INSTALL BATTERY TRAY

   Click here

4. Click here

   INSTALL BATTERY

   Click here

5. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   5.4 N*m

   55 kgf*cm

   48 in.*lbf

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).