OIL LEVEL SENSOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL ENGINE OIL LEVEL SENSOR (w/o DPF)

   
   

   1. Install the engine oil level sensor with the 4 bolts.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

   2. Connect the oil level sensor connector.

2. Click here

   INSTALL ENGINE OIL LEVEL SENSOR (w/ DPF)

   
   

   1. Temporarily tighten the oil level sensor with the 5 bolts.

   2. Fully tighten the bolts A first, and then tighten bolt B.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

   3. Connect the oil level sensor connector.

3. Click here

   INSTALL NO. 2 OIL PAN SUB-ASSEMBLY (w/ DPF)

   Click here

4. Click here

   ADD ENGINE OIL

   Click here

5. Click here

   CHECK ENGINE OIL LEVEL

   Click here

6. Click here

   INSPECT FOR OIL LEAK

   Click here

7. Click here

   INSTALL ENGINE UNDER COVER RH

   Click here

8. Click here

   INSTALL CENTER ENGINE UNDER COVER

   Click here

9. Click here

   OIL MAINTENANCE INFORMATION MODE RESET OPERATION

   (Click here)

10. Click here

    RESET UPPER OIL LEVEL (w/ DPF)

    
    

    1. Warm up the engine until the coolant temperature is 75°C to 86°C (167°F to 187°F).

    2. Drive the vehicle at 15 km/h (9 mph) or more with an engine speed of 1800 to 3000 rpm for 1 minute or more.

       Tip:

       If the upper level switch "off" signal continues for 10 seconds or more, the "oil level high side malfunction" monitor will be reset.