Click here

OIL AND OIL FILTER REPLACEMENT

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

  • Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.

  • Wear protective clothing and gloves. Avoid contact with used oil. If contact occurs, wash your skin thoroughly with soap or waterless hand cleaner. Never use gasoline, thinners, or solvents to wash the skin.

  • In order to protect the environment, dispose of used oil and used oil filters at designated disposal sites only.

Click here

PROCEDURE


  1. Click here

    DRAIN ENGINE OIL


    1. Remove the oil filler cap sub-assembly.

    2. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

    3. Clean and install a new gasket to the oil pan drain plug.

    4. Install the oil pan drain plug.

      37 N*m 377 kgf*cm 27 ft.*lbf
  2. Click here

    REMOVE OIL FILTER


    1. B0046O4E03

      Using SST, remove the oil filter sub-assembly.

      09228-06502
  3. Click here

    INSTALL INSTALL OIL FILTER SUB-ASSEMBLY


    1. Check and clean the oil filter sub-assembly installation surface.

    2. Apply clean engine oil to the gasket of a new oil filter sub-assembly.

    3. Lightly screw the oil filter sub-assembly into place by hand. Tighten it until the gasket contacts the seat.

    4. B0045TYN02

      Using SST, tighten the oil filter sub-assembly.

      09228-06502

      • Depending on the work space available, choose from the following:

      • If enough space is available, use a torque wrench to tighten the oil filter sub-assembly.

      17.5 N*m 178 kgf*cm 13 ft.*lbf

      • If not enough space is available to use a torque wrench, tighten the oil filter sub-assembly 3/4 of a turn by hand or use a common wrench.

  4. Click here

    ADD ENGINE OIL


    1. Add new engine oil and install the oil filler cap sub-assembly.

      Table 1. Standard Oil Grade
      Oil Grade Oil Viscosity (SAE)
      ACEA A3/B4, A3/B3, and API SN

      • 5W-40
      Table 2. Standard Capacity
      Item Standard Condition
      Drain and refill with oil filter change 4.9 liters (5.2 US qts, 4.3 lmp. qts)
      Drain and refill without oil filter change 4.6 liters (4.9 US qts, 4.0 lmp. qts)
      Dry fill 4.7 liters (5.0 US qts, 4.1 lmp. qts)
  5. Click here

    INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no engine oil leaks from the area that was worked on.