OIL PUMP COMPONENTS
ILLUSTRATION
| *1 | EGR VALVE ASSEMBLY | *2 | EGR INLET GASKET |
| *3 | EGR PIPE GASKET | *4 | INTAKE MANIFOLD |
| *5 | NO. 1 INTAKE MANIFOLD TO HEAD GASKET | *6 | ENGINE WIRE |
| *7 | PURGE VALVE (PURGE VSV) | *8 | VENTILATION HOSE ASSEMBLY |
| *9 | NO. 2 FUEL VAPOR FEED HOSE | *10 | NO. 2 WATER BY-PASS HOSE |
| *11 | EGR COOLER ASSEMBLY | *12 | EGR PIPE ASSEMBLY |
| *13 | WATER BY-PASS HOSE | *14 | EGR VALVE BRACKET |
| *15 | NO. 4 WATER BY-PASS HOSE | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants | - | - |
ILLUSTRATION
| *A | for Manual Transaxle | *B | for CVT |
| *1 | V-RIBBED BELT TENSIONER ASSEMBLY | *2 | NO. 1 IGNITION COIL |
| *3 | NO. 2 WATER BY-PASS PIPE | *4 | NO. 6 WATER BY-PASS HOSE |
| *5 | WIRE HARNESS CLAMP BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | CAMSHAFT BEARING CAP OIL HOLE GASKET | *2 | CAMSHAFT TIMING CONTROL MOTOR WITH EDU ASSEMBLY |
| *3 | CAMSHAFT TIMING CONTROL MOTOR O-RING | *4 | CRANKSHAFT POSITION SENSOR |
| *5 | CAMSHAFT POSITION SENSOR | *6 | CYLINDER HEAD COVER SUB-ASSEMBLY |
| *7 | CYLINDER HEAD COVER GASKET | *8 | SEAL WASHER |
| *9 | PLATE WASHER | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Do not apply lubricants | - | - |
ILLUSTRATION
| *1 | WATER INLET WITH THERMOSTAT SUB-ASSEMBLY | *2 | NO. 2 WATER INLET HOUSING GASKET |
| *3 | ENGINE WATER PUMP ASSEMBLY | *4 | CRANKSHAFT PULLEY |
| *5 | STUD BOLT | *6 | TIMING CHAIN COVER OIL SEAL |
| *7 | TIMING CHAIN COVER ASSEMBLY | *8 | NO. 1 TIMING GEAR COVER TIGHT PLUG |
| *9 | CRANKSHAFT PULLEY SET BOLT | *10 | WATER PUMP GASKET |
| *11 | SEAL WASHER | *12 | O-RING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
MP grease |  |
Adhesive 1324 |
| ★ | Precoated part | |
Do not apply lubricants |