WATER PUMP ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT FOR COOLANT LEAK

    Tech Tips


    • The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.

    • Before performing this inspection, check that there is no coolant leaking from any parts other than the water pump. If there are leaks, inspect those areas.

    • Perform this inspection when the engine is cold.


    1. Visually check the engine water pump assembly.


      1. Check that engine coolant is not dripping from the engine water pump assembly.

        Tech Tips


        • If engine coolant is dripping, replace the engine water pump assembly.

        • If engine coolant is not dripping, perform the following check.

    2. Inspect the area around the water pump.

      Tech Tips

      Check for deposits around the drain plug of the water pump.


      1. A01VKMUE04
        Text in Illustration
        *1 Water Pump Pulley
        *2 Drain Plug
        *a Water Pump Pulley Hole

        Rotate the crankshaft pulley and align the water pump pulley hole with the drain plug.

        Tech Tips


        • The drain plug is at the bottom of the water pump.

        • Use a mirror to check that the pulley hole and drain plug are aligned.

      2. A01VDLDE02
        Text in Illustration
        *1 Thin Paper Towel

        Wrap a paper towel around an L-shaped tool such as a hexagon wrench, and insert it into the water pump pulley hole.

        Tech Tips


        • Use a 3 mm (0.118 in.) hexagon wrench.

        • The diameter of the water pump pulley hole is 6 mm (0.236 in.).

        • The distance from the water pump pulley hole to the drain plug is 18 mm (0.709 in.).

      3. A01VHU4E02
        Text in Illustration
        *1 Hexagon Wrench

        Move the hexagon wrench as shown in the illustration, and press the thin paper towel against the coolant (solid matter) adhering to the drain plug or the edge of the drain plug, and check the condition of the thin paper towel.

        Tech Tips


        • If the thin paper towel is wet, replace the water pump assembly.

        • If the thin paper towel is dry, clean the area around the water pump.

  2. INSPECT WATER PUMP ASSEMBLY


    1. Remove the fan and generator V belt Click here.

    2. A01VG1U

      Turn the pulley and check that the water pump bearing moves smoothly and quietly.

      If necessary, replace the water pump assembly.

    3. Install the fan and generator V belt Click here.