EXHAUST GAS TEMPERATURE SENSOR(for Upper Side) INSTALLATION

PROCEDURE


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR


    1. Using a union nut wrench 14 mm, install the exhaust gas temperature sensor to the exhaust manifold.

      Torque:
      Specified tightening torque
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

      • When a union nut wrench 14 mm (fulcrum length of 25 mm (0.98 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 26 N*m (265 kgf*cm, 19 ft.*lbf)

    2. Engage the clamp to connect the exhaust gas temperature sensor wire to the wiring harness clamp bracket.

    3. Engage the claw to connect the exhaust gas temperature sensor wire connector to the wiring harness clamp bracket.

    4. Install the wiring harness clamp bracket to the timing chain cover assembly with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    5. Connect the exhaust gas temperature sensor connector.

  2. INSTALL WIRING HARNESS CLAMP BRACKET

    Click here

  3. INSTALL NO. 1 WIRING HARNESS HEAT INSULATOR

    Click here

  4. INSTALL OUTER COWL TOP PANEL (for LHD)

    Click here

  5. INSTALL OUTER COWL TOP PANEL (for RHD)

    Click here

  6. INSTALL INNER COWL TOP TO COWL BRACE (for LHD)

    Click here

  7. INSTALL INNER COWL TOP TO COWL BRACE (for RHD)

    Click here

  8. INSTALL FRONT AIR SHUTTER SEAL RH (for LHD)

    Click here

  9. INSTALL FRONT AIR SHUTTER SEAL RH (for RHD)

    Click here

  10. INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD)

    Click here

  11. INSTALL FRONT NO. 1 VENTILATOR SEAL (for RHD)

    Click here

  12. INSTALL FRONT WIPER MOTOR AND LINK

    Click here

  13. INSTALL NO. 1 ENGINE COVER

    Click here