EGR VALVE INSPECTION

PROCEDURE


  1. INSPECT ELECTRIC EGR CONTROL VALVE ASSEMBLY


    1. A01VGAJE05
      Text in Illustration
      *a

      Component without harness connected

      (Electric EGR Control Valve Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Condition Condition Specified Condition
      1 (M+) - 2 (M-) 25°C (77°F) 0.3 to 100 Ω

      Tech Tips

      The temperature indicated under "Condition" is the temperature of the electric EGR control valve assembly.

      If the result is not as specified, replace the EGR valve assembly.

  2. VISUAL CHECK ELECTRIC EGR CONTROL VALVE ASSEMBLY


    1. Visually check the electric EGR control valve assembly for deposits.

      If there are deposits, clean the electric EGR control valve assembly.

      Note


      • When cleaning the electric EGR control valve assembly, make sure the valve is completely closed.

      • Do not forcibly open the valve as it may be damaged or deformed.

      • When cleaning the electric EGR control valve assembly, use a piece of cloth soaked with cleaning solvent. Spraying the solvent directly onto these parts or soaking the parts in the solvent may damage the parts.

    2. A01VEKCE02
      Text in Illustration
      *a Clearance
      *b OK
      *c NG

      Hold the electric EGR control valve assembly up to a light, and then from the side indicated by the arrow in the illustration, visually check that there is no gap between the valve and body.

      OK
      No light passes through (there is no gap between the valve and body).

      If light passes through (there is a gap between the valve and body), replace the electric EGR control valve assembly.

      Tech Tips

      Light passes through part A shown in the illustration even if the valve is completely closed; this is not a problem.