ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | ENGINE UNDER COVER RH | *2 | ENGINE UNDER COVER LH |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | INNER COWL TOP TO COWL BRACE | *2 | OUTER COWL TOP PANEL |
| *3 | FRONT NO. 1 VENTILATOR SEAL | *4 | FRONT AIR SHUTTER SEAL RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | INNER COWL TOP TO COWL BRACE | *2 | OUTER COWL TOP PANEL |
| *3 | FRONT NO. 1 VENTILATOR SEAL | *4 | FRONT AIR SHUTTER SEAL RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT SUSPENSION UPPER CENTER BRACE SUB-ASSEMBLY | *2 | FUEL TUBE SUB-ASSEMBLY |
| *3 | NO. 1 FUEL PIPE CLAMP | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | AIR CLEANER CAP WITH AIR CLEANER HOSE | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | BATTERY |
| *5 | BATTERY CARRIER | *6 | BATTERY CLAMP SUB-ASSEMBLY |
| *7 | BATTERY CLAMP BOLT | *8 | BATTERY TRAY |
| *9 | NO. 2 VENTILATION HOSE | *10 | POSITIVE BATTERY TERMINAL |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | EXHAUST PIPE GASKET | *2 | FRONT EXHAUST PIPE ASSEMBLY |
| *3 | FRONT FLOOR CENTER BRACE | *4 | COMPRESSION SPRING |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | RESERVE TANK INLET HOSE | *2 | UNION TO CHECK VALVE HOSE |
| *3 | NO. 1 FUEL VAPOR FEED HOSE | *4 | OUTLET HEATER WATER HOSE |
| *5 | INLET HEATER WATER HOSE | *6 | NO. 3 RADIATOR HOSE |
| *7 | RESERVE TANK OUTLET HOSE | *8 | RADIATOR HOSE |
| *9 | NO. 7 SUB-RADIATOR HOSE | *10 | NO. 4 SUB-RADIATOR HOSE |
ILLUSTRATION
| *1 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH | *2 | ENGINE MOUNTING STAY |
| *3 | ENGINE MOUNTING INSULATOR LH | *4 | COLUMN HOLE COVER SILENCER SHEET |
| *5 | STEERING SLIDING YOKE SUB-ASSEMBLY | *6 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
| *7 | FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | ENGINE WIRE | *2 | WIRE HARNESS CLAMP BRACKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for Bolt with Washer | *B | for Flange Bolt |
| *1 | STARTER ASSEMBLY | *2 | FLYWHEEL HOUSING SIDE COVER |
| *3 | TRANSMISSION CONTROL CABLE ASSEMBLY | *4 | CLUTCH HOSE |
| *5 | MANUAL TRANSAXLE ASSEMBLY | *6 | CLUTCH COVER ASSEMBLY |
| *7 | CLUTCH DISC ASSEMBLY | *8 | FLYWHEEL SUB-ASSEMBLY |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Clutch spline grease |  |
Adhesive 1324 |
| ★ | Precoated part | - | - |
| *T1 | 1st: 49 (500, 36) 2nd: Turn 90° |
- | - |