FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note

      Keep the lip free from foreign matter.

    2. B0046H1E04

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the front crankshaft oil seal retainer edge.

      SST
      09223-22010

      Note


      • Wipe off excess grease from thecrankshaft.

      • Do not tap the timing chain cover oilseal at an angle.

      Tech Tips

      Timing chain cover oil seal tap in depth: - 1.0 to1.0 mm (-0.0397 to 0.0397 in.)

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the crankshaft pulley.

    2. B0047W9C01
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley in place and tighten the bolt.

      SST
      09213-54015
      09330-00021
      Torque:
      190 N*m  { 1937 kgf*cm, 140 ft.*lbf }

  3. INSTALL FAN AND GENERATOR V BELT

    Click here

  4. INSPECT FAN AND GENERATOR V BELT

    Click here

  5. INSTALL FRONT TIRE RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  6. INSPECT FOR FRONT WHEEL RH

    Click here

  7. INSTALL ENGINE UNDER COVER RH

    Click here