ENGINE UNIT REPLACEMENT

PROCEDURE


  1. REPLACE RING PIN

    A01VHP7E04
    Text in Illustration
    *a Upper Side

    Tech Tips

    It is not necessary to remove the ring pins unless they are being replaced.


    1. Remove the ring pins from the camshaft housing.

    2. Using a plastic hammer, tap in new ring pins to the specified protrusion height.

      Protrusion height
      2.7 to 3.3 mm (0.106 to 0.130 in.)

  2. REPLACE STRAIGHT PIN

    A01VIK1E04
    Text in Illustration
    *a Upper Side

    Tech Tips

    It is not necessary to remove the straight pins unless they are being replaced.


    1. Remove the straight pins from the oil pan.

    2. Using a plastic hammer, tap in the straight pins to the specified protrusion height.

      Protrusion height
      5.0 to 7.0 mm (0.197 to 0.276 in.)