REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL ENGINE REAR OIL SEAL


    1. A01VGWV

      Apply engine oil to a new oil seal lip.

      Text in Illustration
      A01VEA4 Apply Engine Oil
    2. A01VLHSE01

      Using SST and a hammer, evenly tap the oil seal until its surface is flush with the rear oil seal retainer edge.

      Standard depth
      -0.5 to 1.0 mm (-0.0197 to 0.0394 in.)
      SST
      09223-15020
      09950-70010   ( 09951-07200 )

      Note


      • Keep the lip free from foreign materials.

      • Do not tap on the oil seal at an angle.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. Using SST, hold the crankshaft.

      SST
      09960-10010   ( 09962-01000, 09963-01000 )

    2. Clean the 6 bolts and 6 bolt holes.

    3. A01VF4ZE52
      Text in Illustration
      *1 Adhesive

      Apply adhesive to the 2 or 3 end threads of the bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.
    4. A01VJPZE01

      Install the flywheel with the 6 bolts in the order shown in the illustration.

      Torque:
      78 N*m  { 795 kgf*cm, 58 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

  3. INSTALL CLUTCH DISC ASSEMBLY

    Click here

  4. INSTALL CLUTCH COVER ASSEMBLY

    Click here

  5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

    Click here

  6. INSTALL MANUAL TRANSAXLE ASSEMBLY

    Click here