HEATED OXYGEN SENSOR(for Sensor 1) INSTALLATION

PROCEDURE

1. INSTALL HEATED OXYGEN SENSOR (Sensor 1)

   Tech Tips

   Perform "Inspection After Repairs" after replacing the heated oxygen sensor (sensor 1).

   Click here

   
   
   1. 

      *a	Torque Wrench Fulcrum Length
      *b	SST Fulcrum Length

      Using SST, install the heated oxygen sensor (sensor 1) to the exhaust manifold converter sub-assembly.

      SST

      09224-00012

      Torque:

      Specified tightening torque

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor (sensor 1).

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 39 N*m (398 kgf*cm, 29 ft.*lbf)

   2. Engage the 2 wire harness clamps.

   3. Connect the heated oxygen sensor (sensor 1) connector.

2. INSTALL OUTER COWL TOP PANEL (for LHD)

   Click here

3. INSTALL OUTER COWL TOP PANEL (for RHD)

   Click here

4. INSTALL INNER COWL TOP TO COWL BRACE (for LHD)

   Click here

5. INSTALL INNER COWL TOP TO COWL BRACE (for RHD)

   Click here

6. INSTALL FRONT NO. 1 VENTILATOR SEAL (for LHD)

   Click here

7. INSTALL FRONT NO. 1 VENTILATOR SEAL (for RHD)

   Click here

8. INSTALL FRONT AIR SHUTTER SEAL RH (for LHD)

   Click here

9. INSTALL FRONT AIR SHUTTER SEAL RH (for RHD)

   Click here

10. INSTALL WINDSHIELD WIPER MOTOR AND LINK

    Click here

11. INSPECT FOR EXHAUST GAS LEAK

    Click here

12. PERFORM INITIALIZATION

    
    

    1. Perform "Inspection After Repairs" after replacing the heated oxygen sensor (sensor 1).

       Click here