KNOCK SENSOR INSTALLATION

PROCEDURE


  1. INSTALL KNOCK SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the knock sensor.


    1. B0045A1C02
      *a +/- 10°

      Install the knock sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note


      • If the knock sensor has been struck or dropped, replace it.

      • Make sure that the knock sensor is in the correct position.

    2. Connect the knock sensor connector.

  2. INSTALL SUPERCHARGER ASSEMBLY

    Click here

  3. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the knock sensor.

      Click here