IGNITION COIL AND SPARK PLUG REMOVAL

PROCEDURE


  1. REMOVE FRONT SUSPENSION UPPER CENTER BRACE SUB-ASSEMBLY

    Click here

  2. REMOVE IGNITION COIL ASSEMBLY


    1. B0047MR

      Disconnect the 4 ignition coil assembly connectors.

    2. B00475B

      Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

      Note

      If a component has been dropped or subjected to a strong impact, replace the ignition coil assembly.

  3. REMOVE SPARK PLUG

    Tech Tips

    Due to interference with the cowl top ventilator louver sub-assembly, the spark plug wrench, 100 mm extension bar and 75 mm extension bar cannot be inserted into the plug hole while they are assembled together, so use the following procedure to set the tools on the spark plug.

    B0047X9C01
    *1 Cowl Top Ventilator Louver Sub-assembly
    *2 Plug Hole
    *3 Spark Plug
    *a Spark Plug Wrench
    *b 100 mm Extension Bar
    *c 75 mm Extension Bar

    1. Set the tools on the spark plug.

      B0045DTC01
      *1 Spark Plug - -
      *a Spark Plug Wrench *b 100 mm Extension Bar
      *c 75 mm Extension Bar - -

      1. Connect the spark plug wrench and the 100 mm extension bar. (A)

      2. Insert the assembled spark plug wrench and 100 mm extension bar into the plug hole and set them on the spark plug. (B)

      3. Connect the 75 mm extension bar to the 100 mm extension bar. (C)

    2. B00482U

      Remove the 4 spark plugs.

      Note

      If a component has been dropped or subjected to a strong impact, replace the ignition coil assembly.