HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. A0047TOC01
      *a SST Fulcrum Length
      *b Torque Wrench Fulcrum Length

      Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace the heated oxygen sensor.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

        39 N*m (398 kgf*cm, 29 ft.*lbf)

    2. Engage the clamp to connect the heated oxygen sensor wire to the wire harness clamp bracket.

    3. Connect the heated oxygen sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here