CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. for Intake side:


      1. A0049DJ

        Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

        Note

        If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note


        • If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.

        • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      3. Connect the camshaft position sensor connector.

    2. for Exhaust side:


      1. A0049DJ

        Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

        Note

        If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note


        • If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.

        • Make sure that the O-ring is not damaged or does not jump out of position during installation.

        Tech Tips

        If the hose clip of the No. 2 ventilation hose was moved during removal, slide the hose clip back to its original location.

      3. Connect the camshaft position sensor connector.

  2. INSPECT FOR ENGINE OIL LEAK

    Click here

  3. INSTALL NO. 1 ENGINE COVER

    Click here