WHEN USING GTS
CAUTION:
Observe the following items for safety reasons:
Read the GTS instruction books before using the GTS.
Make sure that the GTS cable is not caught on the pedals, shift lever and steering wheel when driving with the GTS connected to the vehicle.
When driving the vehicle for testing purposes while using the GTS, 2 persons are required. One person drives the vehicle and the other operates the GTS.
INITIALIZATION
Note
Perform Registration (VIN registration or frame number registration) when replacing the ECM.
Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).
Make sure to perform Reset Memory (CVT initialization), deceleration sensor zero point calibration and CVT oil pressure calibration when replacing the ECM or the oil pressure sensor.*1
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
When replacing the engine stop and start ECU with a new one, make sure to download the previous status (number of starter operations) of the old engine stop and start ECU.*2
When the starter assembly is replaced, the number of starter operations stored in the engine stop and start ECU must be reset.*2
When the starter assembly is replaced, "ST relay" and "ST NO. 2 relay*1" must be also replaced.*2
*1: for CVT
*2: w/ Stop and Start System
IGNITION SWITCH EXPRESSIONS
Tech Tips
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |