AIR FUEL RATIO SENSOR INSTALLATION

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

   
   

   1. Using SST, install the air fuel ratio sensor onto the exhaust manifold.

      SST

      09224-00010

      Torque:

      without SST

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      with SST

      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a component has been dropped or subjected to a strong impact, replace it.

      Tech Tips

      
      

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values Click here.

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor Click here.

   2. Connect the connector of the air fuel ratio sensor.

   3. Engage the clamp and connect the air fuel ratio sensor wire to the wire harness clamp bracket.

2. INSPECT FOR EXHAUST GAS LEAK

   Tech Tips

   Perform "Inspection After Repairs" after repairing or replacing the exhaust system Click here.

3. INSTALL NO. 1 ENGINE COVER

   Click here