MANIFOLD ABSOLUTE PRESSURE SENSOR ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR


    1. A01VE9HE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Manifold Absolute Pressure Sensor)

      Inspect the power source voltage.


      1. Disconnect the connector of the manifold absolute pressure sensor.

      2. Turn the ignition switch to ON.

      3. Measure the voltage between the terminals of the manifold absolute pressure sensor connector.

        Standard Voltage
        Tester Connection Switch Condition Specified Condition
        B35-3 (VC) - B35-1 (E2) Ignition switch ON 4.5 to 5.5 V

      4. Turn the ignition switch off.

      5. Reconnect the connector of the manifold absolute pressure sensor.

    2. Inspect the vacuum.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON and turn the intelligent tester on.

      3. Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

      4. Read the value.

        OK
        Same value as the actual atmospheric pressure

        Tech Tips

        Condition MAP Value (Reference)
        Ignition switch ON 80 to 110 kPa (600 to 825 mmHg, 24 to 32 in.Hg)
        Idling 28 to 48 kPa (210 to 360 mmHg, 8 to 14 in.Hg)