HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL HEATED OXYGEN SENSOR

   
   

   1. Using SST, install the heated oxygen sensor onto the front exhaust pipe assembly.

      09224-00010

      without SST
      44 N*m	449 kgf*cm	32 ft.*lbf
      with SST
      40 N*m	408 kgf*cm	30 ft.*lbf

      Tip:
      

      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here).

   2. Connect the connector of the heated oxygen sensor.

   3. Engage the clamp and connect the heated oxygen sensor wire to the wiring harness clamp bracket.

2. Click here

   INSPECT FOR EXHAUST GAS LEAK

   Tip:

   Perform "Inspection After Repairs" after repairing or replacing the exhaust system (Click here).